Glossary of Terms
This is the new minimum efficiency standard (effective January 2006) for an air conditioner or heat pump. All units newly manufactured must meet this standard. Previously manufactured equipment may be sold, and installed until they run out of supply. SEER is defined later.
The Air Conditioning Contractors of America, a national trade association that represents heating, ventilation, air conditioning, and refrigeration contractors.
Annual Fuel Utilization Efficiency, a measure of heating efficiency. A higher AFUE denotes higher efficiency. The current minimum is 78%.
AIR HANDLING UNIT
Equipment with a heating element and/or cooling coil and other components in a cabinet or casing.
Air-Conditioning and Refrigeration Institute, a non-profit, voluntary organization composed of heating, air conditioning and refrigeration manufacturers. ARI publishes standards for testing and rating heat pumps and air conditioners.
BALANCING or AIR BALANCING
Adjusting an air conditioning system so that the right amount of air is delivered to the right places in your home in order to achieve the right heating or cooling effect.
The Building Performance Institute (BPI) offers nationally-recognized training, certification, accreditation and quality-assurance programs.
British Thermal Unit, the measurement of heating and air conditioning capacity. A BTU is the amount of heat that must be added to one pound of water to raise its temperature one degree Fahrenheit.
Chlorofluorocarbons, used as a refrigerant in air conditioners and heat pumps, linked to the depletion of the ozone layer.
A Btuh is the number of Btus used in one hour.
Coefficient of performance, an efficiency ratio that compares the amount of heat delivered to the amount of energy used. As with MPG on a car, the higher the score the more energy efficient the equipment is.
A heating or cooling element made of pipe or tubing, usually with plates or fins.
The final step in installing a heating or air conditioning system. Every component is checked and tested for compliance with codes, ACCA manuals, manufacturer requirements, and occupant needs. After commissioning, the technician will: provide documentation of testing, provide all equipment manuals, and show the homeowner how to operate the system.
CONDENSER (HEAT EXCHANGER)
The outside unit of a heating or air conditioning system. Here the refrigerant condenses from a gas to a liquid and hot or cold air from the building is released to the outside.
Db is a rating system for noise levels. One decibel is close to the Just Noticeable Difference (JND) for sound level. Meaning if you can tell one sound is louder than another sound they are separated by at least one decibel.
A device that removes excess moisture from the air.
The U.S. Department of Energy, the federal agency that sets industry efficiency standards.
Discount Service Plan, which provides regular maintenance of your HVACR system. Most ACCA member contractors offer DSPs, although they may use different names for them, such as Maintenance Inspection Agreement, Planned Service Agreement, Energy Service Plan, etc.
Conduits used to carry air. They can be round or rectangular, sheet metal or fiberglass or vinyl tubes. In air conditioning systems they carry air from the home to the air conditioning system or furnace and back to the home.
Energy Recovery Ventilator, a machine that draws fresh air into the home and exhausts stale air from the home. It uses a process to preheat or pre-cool (depending on the season) to reduce energy costs associated with conditioning the air.
A government supported branding used to identify energy efficient products. The branding was developed by the US Department of Energy and the US Environmental Protection Agency.
The U.S. Environmental Protection Agency.
See AIR HANDLING UNIT
A self-contained heating unit that is designed to deliver heated air to a home.
Gas Appliance Manufacturing Association is a national trade association serving the interests of manufacturers of gas, oil, and electric appliances and equipment, components and related products used in residential, commercial, and industrial applications.
Hydrochlorofluorocarbons, used as a refrigerant in air conditioners and heat pumps. HCFCs were thought to contribute to the depletion of the earth’s ozone layer.
1. The part of a furnace that transfers heat from burning fuel to the air used to heat your home. Also, from a boiler to water for hydronic heating.
2. A device, such as a condenser or evaporator, in which heat is added or removed in order to heat or cool your home.
A single refrigeration system designed to provide both heating and cooling. Compare to a furnace and an air conditioner, separate units that only heat or cool.
Heat Recovery Venilator, a machine that brings fresh air into a home through a process that preheats the air so it has less impact on your utility bill.
Hydroflorocarbon, used as a refrigerant in air conditioners and heat pumps. It has little or no effect on the ozone layer.
Heating Seasonal Performance Factor, an equipment efficiency rating. As with MPG on a car, the higher the rating the more fuel efficient the equipment is. The current minimum is 6.8
A device that adds moisture to warm air for your home.
Heating, ventilating, and air conditioning
Heating, ventilating, air conditioning, and refrigeration
Air that enters your home through holes, gaps, and cracks, (e.g., plumbing or electrical holes, the heating and air conditioning system, doors, and windows).
Indoor air quality
The energy that suspends moisture vapor in the air.
A mathematical determination of how much cooling and heating (BTUs) an HVAC system must deliver for occupant safety and comfort. It is based on a variety of factors: square footage, building orientation, number of occupants, size and placement of rooms, number and size of windows and doors, amount of insulation, number of floors, and climate.
An ACCA procedure covering the proper design, installation, maintenance, and repair of ductwork.
An ACCA procedure covering the method for calculating heating and cooling requirements (load calculation) for single-family detached homes and mobile homes.
An ACCA publication covering the design, installation, and commissioning of a residential HVAC system.
An air conditioner or heat pump system composed of equipment that has been certified by ARI to work together to deliver the specified heating and cooling capacity at the stated efficiency rating.
A natural byproduct of the fungi family that thrives when organic substances and water combine under certain circumstances. Mold reproduces via spores that can remain dormant, yet viable, for years. Many molds are beneficial. For example, they are the “bleu” in bleu cheese, and we use them to make wine, penicillin, and antibiotics. However, some molds can cause health problems.
North American Technician Excellence, the nonprofit organization that tests and certifies HVACR technicians.
A refrigerant containing chlorine used in air conditioning systems. The EPA has mandated that R-22 cannot be manufactured after 2010 because it has been linked to the depletion of the ozone layer and global warming. Most commonly referred to by its trademarked name, Freon.
The refrigerant that replaces R-22. It does not contain chlorine and is not hazardous to the environment.
A fluid that absorbs heat at low temperatures and rejects heat at higher temperatures.
REFRIGERANT CHARGE (or, “charging the refrigerant”)
The procedure an HVACR technician performs to ensure that the system has enough of the right kind refrigerant for peak operating performance.
RELATIVE HUMIDITY (RH)
The percent of moisture actually in the air compared to the maximum amount of moisture the air can hold at that temperature.
RETURN, RETURN AIR, RETURN SIDE
The path the air takes to get to an air-handling unit or furnace so it can be cooled or heated. It is the “return” path. The return side should be “balanced” with the supply side to ensure proper air flow and comfort.
Seasonal Energy Efficiency Ratio, an equipment efficiency rating that measures how much energy it takes to cool the air. As with MPG on a car, the higher the number the more efficient the unit. The current minimum is 10, which was considered “high efficiency” a few years ago.
The temperature of the air. This type of heat is measured with a thermometer.
A two-component heating and cooling (heat pump) or cooling only (air conditioner) system. The condensing unit is installed outside, the air handling unit is installed inside (preferably in conditioned space). Refrigerant lines and wiring connect them together.
SUPPLY or SUPPLY SIDE
The part of an HVAC system that takes (supplies) the conditioned air from the air-handling unit or furnace to your home. The supply side should be “balanced” with the return side to ensure proper air flow and comfort.
A measure of energy equal to the amount of heat required to melt one ton of ice in a 24 hour period. 12,000 Btus = 1 ton.
ZONES, ZONED SYSTEM, ZONING
A single HVAC system that can meet different heating and cooling needs in different areas (zones). Each zone of a home has its own thermostat with which it can regulate the temperature and humidity in its area. One “zoned air conditioner” could be set for a high temperature in one zone and for a lower temperature in the other zone. Zone systems have two or more zones.